Wine Cork Bulletin Board

My daughter doesn’t have much wall space in her bedroom and wanted someplace to be able to pin up small mementos, cards, etc. There is a narrow space next to her closet that a typical bulletin board would not fit in so, of course, I decided to make one. The cost? $10

Similar to the wreath, I cut wine corks in half with a sharp knife and used hot glue (multi temp) to attach them to a piece of Styrofoam. You can cut Styrofoam into any shape that will work for you. The glue holds well to the foam, better than other backings I have found.

IMG_4506

I simply glued them in a two over two pattern since they are roughly the same size. You may need to cut the corks to fit near the ends so they will be flush to the edge. Alternate the cut ends for a more even look. (I learned this later, sad face). One of the most interesting things I learned with this project is that you can cut open the rubber corks and hot glue them as well. In the past, I didn’t use them because they would not stick with the glue but this was the first time I tried gluing the inside of the cork and it worked! (note the black corks below)

IMG_4509

Once the foam was completely covered, we needed to figure out how to hang it on the wall. I pinned ribbon around the edges to hide the foam and add some color. The photos are a little misleading in that you CAN see some of the foam through the corks. I think this is because I didn’t take the time to cut them and make them fit tightly. You can certainly do a better job on yours! My daughter will just be covering the gaps with stuff. I used eye screws at the top, screwed into the corks. Then the same ribbon was threaded through to make a hanger.
  

Advertisements